ACTIVE

Category:

Wired safety edge

The Sensitive Edge ACTIVE is a safety device for sliding gates and protection for moving objects: it ensures the protection of people and property from impacts caused by moving mechanical organs such as sliding gates and automatically closing doors.

The sensitive edge, due to its technical characteristics, is active in all positions (including the upper and lower ends) and the obstacle is detected along its entire length: the deformation of the rubber causes the sensitive edge to intervene along its entire height.

Safety edges are made to avoid the risk of crushing of sliding doors, electric gates, moving bulkheads, and other systems.

ACTIVE edge is easy to install and is available in sizes of 1.50 – 1.70 – 2.00 – 2.50 mt.

TECHNICAL DATA:
– Response time: 0.1 sec;
– Contact output J1: NC or 8.2KΩ;
– Contact rating: 5A-250Vac;
– Operating temperature: -10°C, 60°C;
– Degree of protection: IP54;
– Maximum sensing speed: 12m/min;
– Strain recovery time: < 2 sec.

Find out the other safety edges: ACTIVE-R3, radio safety edge; CAPTIVE, Crashless (crash avoidance) safety edge.

 

REQUEST INFORMATION

Related products

  • Sistema captive - bordi di sicurezza resistivi

    CAPTIVE

    Read more

    CRASHLESS safety edge

    The CAPTIVE crashless resistive edge is certified as a class 2 safety device according to EN 12978
    The CRASHLESS ("impactless") function allows, for most of the gate's travel, to avoid collision with obstacles, cars or people.
    The two inhibitory magnets perform a dual function: - they deactivate the capacitive part when the gate is stopped to save battery life - during the closing phase, the capacitive device would read the closing column as an obstacle, but the magnets connected to the receiver inhibit the crashless function, leaving the safety edge active
    It is recommended to synchronize the inhibition of the capacitive function with the slowing down of the motor to more easily fall within the crash force limits imposed by current regulations.
    Available in sizes 1.20 - 1.60 - 2.00 - 2.50 mt.
    TECHNICAL DATA: - Operating temperature: -20°C, 55°C; - Operating consumption: 12 mA - Frequency: 868 Mhz - Degree of protection: IP65;
    Discover other sensitive security edges: ACTIVE, wired security edge; ACTIVE-R3, radio security edge.

  • P37B

    Read more
    P37B-Batteries movable photocells.
    Receiver: - Power Supply: 12/24 Vcc/ca - Absorption: 35mA -Relay Range: 1A-24V -Range: 10-15m Transmitter: - Power Supply: 3V ( n.2 alkaline batteries AAA 1.5V) -Absorption: 25mA -Range: 10m (open PJ)/15m (closed PJ) - Operating Temperature: -20 to +60° Data Sheet Instruction Manual
  • fotocellula a luce polarizzata REFLEX - portata da 8 a 15 mt

    REFLEX

    Read more
    Polarized light photocell
    The polarized light photocell REFLEX is quick and easy to install: the wiring, in fact, takes place only on one side, while on the opposite side it is sufficient to place the reflector at the same height as the photocell. Alignment between the two elements is facilitated by positioning LEDs. The range of the REFLEX photocell varies from 8 to 15 mt, depending on the retro-reflector: - rectangular - 8 mt - round - 12 mt - square - up to 15 mt In addition, the wide range of accessories ensures its excellent reliability and preserves the photocell from condensation, rain, shocks and reflections. TECHNICAL DATA:. - Power supply: 10..36 Vdc / 24 Vac 25% - Operations and power consumption: < 100 ms on / max 30mA/24V - Light type and cone opening: 68 0nm / approx. 1.50 total angle - Delay: < 10 ms - Range (depending on reflector): 8mt - rectangular, 12mt - round, 15mt - square - Cable connections: max 1.5mm2 - Protection Degree: IP65 (EN60529); - Operating temperature: -25° / 60°. - Dimensions (LxWxH) and weight: 86 x 44 x 39 mm / 60 gr. WARNING: It is important to recognize the real REFLEX photocell from the copies. To make sure you are using the original, check out our pdf guide "How to recognize the REAL REFLEX".
  • Micro fotocellula micro-p27s, con sincronismo, relè reed

    MICRO P27S

    Read more
    Micro photocell with synchronism and REED relay
    MICRO-P27 is a micro photocell with a miniaturized design that easily fits any fixing space - even the smallest ones, and guarantee a minimal visual impact of the photocell on the automation. The miniaturized design is typical of the MICRO range (Micro-Flash, Micro-Traffic, Micro-RGB). The integrated micro relay with REED technology, and without levers, also ensure a long lifespan and a wider power supply range - compared to traditional relays. Discover the other products of the MICRO range: MICRO-FLASH, lampeggiatore a led da parete; MICRO-TRAFFIC, led traffic light; MICRO-RGB, led signal light - RGB. TECHNICAL FEATURES: - Power supply: 12-24 Vdc/ca - Absorption: 60 mA - Relay: REED TECHNOLOGY - Max door width: 15 m - Relay capacity: 0,5 A - 24 V - Frequency: 1500 Hz - Light: modulated infra-red - Operating temperature: : -20°C, +60°C - Weight (plastic): 12gr [video src="https://www.abexo.tech/wp-content/uploads/2019/10/video_P27_teaser_v_3-1.mp4.mp4"]
     
Top